Routed WAN network

For this lab we wanted to simulate a WAN network.  We divided up into 5 groups of people and we all got routers.  We used serial port connections between each router and we were given a ip and the subnet and we were told to make a routable ip from that and then see if we could ping across the network.  We went along and went into the router's config with telnet and we set up the interfaces and the clockspeed to see how its done.  The commands we used were enable then config.  Then we used the int s0/0 and int s1 commands to check the interfaces and change the ip's of the serial ports.  We found out later when we tried to route across the network we used an incorrect IP setup.  We were trying to use a private ip to work the subnets off of.

This is what it looks like when you console into the router.  As shown by brad.  Weeeeeee!

We used putty to console in the router.